NC29 Dip Stick measurement.

Post by **RSVR** » Sat Jun 09, 2012 9:51 am

NC29 Dip Stick measurement.

Can someone please measure the length of the NC29 dipstick indicator.
The reason for this seemingly daft question is:
I’ve just carried out an oil and filter change, and replenished with 3.4 Ltr’s of oil, but nothing registers on the D-Stick.

I need an accurate measurement to compare against the one currently installed.
Obviously it's on level ground.

Thanks in advance.
RSVR

nazzurro_19 · Post by **nazzurro_19** » Sat Jun 09, 2012 9:58 am

May sound stupid but is it cause the oils new it looks see through you might be missing it

Post by **RSVR** » Sat Jun 09, 2012 10:11 am

No,

The Dip sticks dry!

gullarm · Post by **gullarm** » Sat Jun 09, 2012 10:12 pm

doesnt the bike have to upright - not on side stand, as if you were sitting in it?

nazzurro_19 · Post by **nazzurro_19** » Sat Jun 09, 2012 10:38 pm

It does yeah

Post by **RSVR** » Sun Jun 10, 2012 11:58 am

Chaps,

Obviously!

Can anyone please measure!!!

Post by **Davez29** » Sun Jun 10, 2012 2:45 pm

Ok, I was waiting to see if anyone else could do it for ya as I was only using my phone its a pain cutting and pasting...

This is from a post I answered on another site where someone posted a similar question.

Length of stick, taken from just under the plastic knob is 49mm. High mark 37mm and mid point is 44mm. All taken with a plastic ruler so is not perfect but should get you away. Go for 44mm ish. Level from the normal knob resting point.

I know flling with oil I always seem to add more than recommended.

dave

gullarm · Post by **gullarm** » Sun Jun 10, 2012 3:17 pm

Ill second that.

Around 49mm from base of knob to end of dipstick.

From the bottom of the dipstick to the max oil marker looks around 10mm.

Took a photo but forget how to add them on here!

I wonder if its possible to push the dipstick into the plastic knob - so marking it shorter? Not on purpose of course, say if you dropped it.

Its also poss you have a different bikes dip stick, I suppose if the previous owner lost it they would bang any one on and worry about it later.

Post by **Davez29** » Sun Jun 10, 2012 4:35 pm

It should have a KT8 part number printed on top.

Post by **RSVR** » Sun Jun 10, 2012 5:11 pm

Chaps,

Many thanks I do appreciate it.

Well it's short...... from the plastic base to the tip is just 40mm, the high mark is at 26mm.

Anyone know the part number of the correct D-Stick.

Thanks again

RSVR

NC29 Dip Stick measurement.

NC29 Dip Stick measurement.

Re: NC29 Dip Stick measurement.

Re: NC29 Dip Stick measurement.

Re: NC29 Dip Stick measurement.

Re: NC29 Dip Stick measurement.

Re: NC29 Dip Stick measurement.

Re: NC29 Dip Stick measurement.

Re: NC29 Dip Stick measurement.

Re: NC29 Dip Stick measurement.

Re: NC29 Dip Stick measurement.