3TJ swingarm bearings
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Clanky
- NWAA Supporter
- Posts: 88
- Joined: Sun Feb 06, 2011 9:41 pm
- Bike owned: FZR 400 3EN1, FZR 600 3HE
- Location: UK
-
rockTJ
- Settled in member
- Posts: 207
- Joined: Sat Mar 31, 2012 3:43 pm
- Bike owned: GSX650F FZR250x2 RSV RG80
- Location: Southend-on-Sea
Re: 3TJ swingarm bearings
The bearings in that link are not shell type needle roller bearings?????
The only one listed as having a 17mm shaft size has an outer diameter of 35mm, well over the 24mm needed.
Maybe special order with them
The only one listed as having a 17mm shaft size has an outer diameter of 35mm, well over the 24mm needed.
Maybe special order with them
-
Clanky
- NWAA Supporter
- Posts: 88
- Joined: Sun Feb 06, 2011 9:41 pm
- Bike owned: FZR 400 3EN1, FZR 600 3HE
- Location: UK
Re: 3TJ swingarm bearings
Hi Chris,
The bearings I listed were for the swingarm relay in case you wanted to replace the bearings in that while you were doing those in the swingarm. Didn't mean to cause any confusion
Try these blokes for bearings:
http://shop.marksman-ind.com/motorcycle ... uk-2-c.asp
The bearings I listed were for the swingarm relay in case you wanted to replace the bearings in that while you were doing those in the swingarm. Didn't mean to cause any confusion
Try these blokes for bearings:
http://shop.marksman-ind.com/motorcycle ... uk-2-c.asp
-
rockTJ
- Settled in member
- Posts: 207
- Joined: Sat Mar 31, 2012 3:43 pm
- Bike owned: GSX650F FZR250x2 RSV RG80
- Location: Southend-on-Sea
Re: 3TJ swingarm bearings
Ah ok. I'm trying to save as much as possible including old bearings. I will check and liberally regrease as I rebuild it. I dont think it will take long to get the frame/forks built up but there on in may take a while Both wheels will need powder coating which means more bearing shenanigans!
Chris
Chris