My new NC35 RC211V edition

[andreasmkr]

Hi.

Here is my freshly finished NC35.
It has been completly overhauled from the inside and out.

Specs:

08 GSX-R 600R complete front end with original rim
08 GSX-R 600R rear shock
Moto GP Custom made exhaust
Koso Rx1 speedo
Renthal Clip-Ons
SSR quick fuel cap
Original Honda HRC tank protector
Scorpio SR500i alarm system with remote shutdown
Pro-Bolt complete fairing and engine set
Pazzo racing levers
Powder coated swingarm
Powdercoated NC35 rear rim
Powdercoated engine case cover
GSX-R 600R rear master cylinder
Rear brake hose mod
Samco hose set
Portet heads
GlowGauge voltmeter
Yamaha R-6 rectifier
New custom made generator
New brake discs
Braided Front and Rear brake hoses
"unknown" Rearset
3M Carbon wrap tape (Hard to get the detail with a camera, but looks like real carbon fibre)

































Hope you guy's enjoy it as much as I do!

[Hadies]

Very trick! I bet that wasn't cheap. Good work.

[CMSMJ1]

err...

Errr...


Err....I can see some effort has gone into it, which is cool..but...that exhaust?

The front end swap is a good idea - how does it work? What did you do to sort it?

[andreasmkr]

err...

Errr...


Err....I can see some effort has gone into it, which is cool..but...that exhaust?

The front end swap is a good idea - how does it work? What did you do to sort it?

The exhaust was acutally like that when I got the bike from Thailand I just added a custom exhaust silencer to it.

The front end forks great! I just had to swap out the steering stem bearings to fit the NC35 frame.

[Cammo]

Some cool mods there, love the front end!

I'm with Mark on the exhaust. It looks like a standard nc35 exhaust that's been modified? A full aftermarket system would be nicer IMO and give some performance gains.

Don't think I could live with the ignition switch like that either - I hope it's not permanent.

I've used the 3m carbon wrap, it does look very close to real carbon fibre when seen in person.

Good effort!