Sharkfin issue (racing)

Post by **ChowderV4** » Sun Jan 20, 2013 5:47 pm

Just found that the mount on the swingarm where you'd bolt the sharkfin to has been snapped off at some point, the issue is i cant race without one fitted.
Anyone have any bright ideas of how or where i can bolt one on?

alexwitham · Post by **alexwitham** » Sun Jan 20, 2013 5:51 pm

Post a pic of the broken mount

Post by **ChowderV4** » Sun Jan 20, 2013 6:22 pm

alexwitham wrote:Post a pic of the broken mount

Dont have a computer at the mo to get photos up, but basically its not got anything left on the swingarm of the mount at all. Only thing i can think of is welding a nut where the mount was. Bit rough but should work.

Post by **porndoguk** » Sun Jan 20, 2013 6:46 pm

grind it flat and either:-

rivet, or drill and tap into the swingarm, or self tapping screws,

Post by **ChowderV4** » Sun Jan 20, 2013 6:59 pm

porndoguk wrote:grind it flat and either:-

rivet, or drill and tap into the swingarm, or self tapping screws,

Ah thats probably better than welding anything. Will give that a go.

Sharkfin issue (racing)

Sharkfin issue (racing)

Re: Sharkfin issue (racing)

Re: Sharkfin issue (racing)

Re: Sharkfin issue (racing)

Re: Sharkfin issue (racing)