How to fit the 600 into the 3tj

[Evilchicken0]

The wiring diagrams are in the service manuals
Got to the front page of this site then documents on the top right
http://www.400greybike.com/docs.htm

[zxrjohn14]

awesome!!
thanks for that.
i'm off into the garage armed with snippers, electrical tape and the lap top
(might not be so happy in an hour or so!)

[Evilchicken0]

This is no time for watching porn on the laptop

Open up a build thread

[zxrjohn14]

I would open a thread but I'm pants with loading pictures etc.
The good news is thanks to this thread i have managed to get it running!!
You would not believe how happy i am.
Thanks for putting me on to the wiring diagrams evil one :)

[Evilchicken0]

I would believe it.

No probs

[J_oram]

Hi guys,

my first post here. I read al the pages of this topic. Nice to read, but I also have the same problem as Nick en Hunter. My sprockets are not alignment. I have a 4dx frame with a 4jh motor.

Hunter said that he cut some of his bottom mount away.(page 12) But which mount is it?

Thanks for the reply.

[Evilchicken0]

it's the top mount on the generator side - you need to take out the depth of the plate.
The other side (clutch side) has 2 spacers - you discard them and replace them with the plat and a packer if you need them (the plat + packer = spacer)

[J_oram]

Oke thanks, but that is the same handeling as with the 3tj I think?

[Evilchicken0]

You need plates for the top mounts so on the left or generator side you need to make enough space to fit it.

[J_oram]

Yes I think I understand it, we shall see. I beginning the build-up on 27 april. First I have a circuit day with the 400. Thanks for the help.