DIY FCR inlet boots

Yakama · Post by **Yakama** » Fri Oct 28, 2016 1:25 pm

But you would need to make the manifolds offset to compensate so they would need to be one off specific to these NC29 FCR's?

Post by **Maelstrom** » Sun Oct 30, 2016 3:16 am

Yes, they almost all have that issue. When I said cut and fit I also meant cut and bend the tubes. Multiple cuts will give a smooth enough bend.

Yakama · Post by **Yakama** » Sun Oct 30, 2016 9:33 am

Ok what so is something we can get going then?

Post by **Maelstrom** » Sun Oct 30, 2016 11:38 am

I am quite sure I saw rubbers and aluminium spigots for FCR's on Webike or similar. Maybe JB Power brand or genuine Keihin.

I am converting my own bike, an FZR400 3TJ1, from the one piece rubber parts to the same setup. I will be using the earlier model 1WG style rubbers that I have in Viton, http://www.litetek.co/InletManifoldRubb ... a_1WG.html and making blank spigots which I will also sell because they will fit all the bikes that use the same bodies.

matt69 · Post by **matt69** » Sat Dec 31, 2016 12:06 am

selexon wrote:Hey All,

I have my original set of FCR rubber adapter on my bike.

More then happy to loan these to get the copied to help out.

Let me know if they are needed. And whom to talk to? That or i can possibly get them across to a rubber/plastic supplier I use in Italy and get them to supply a quote on costing.

Selexon,

I've found 2 places in Australia that should be able to replicate these for us. I''m happy to organise this if you are still willing to lend us your manifolds.

Matt

Yakama · Post by **Yakama** » Mon Jan 09, 2017 1:58 pm

I've managed to find a set so have contacted a company over here

DIY FCR inlet boots

Re: DIY FCR inlet boots

Re: DIY FCR inlet boots

Re: DIY FCR inlet boots

Re: DIY FCR inlet boots

Re: DIY FCR inlet boots

Re: DIY FCR inlet boots