Breaking apart my NC29 project.
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Reactions:
- Posts: 26
- Joined: Fri Apr 11, 2014 2:38 pm
- Bike owned: KTM 990 Adv and NC29
- Location: Gosport/Hull
Breaking apart my NC29 project.
So, I'm selling off my project CBR due to the cash flow drying up with a new house and all, so I have a lot of bits to sell off if anyone is interested, including, but not limited to;
Carbs which have been ultrasonically cleaned and dynojet needles installed
Set of SAMCO hoses.
ZXR 400 front end, fit for NC29, with ZXR 400 front wheel, 310mm brake discs and six pot calipers from GSX-R 1000 with spacer to fit.
Wheels with Bridgestone BT 090 tires, only 300miles on them. Cush rubbers replaced and not used, brand new renthral rear sprocket.
Rear shock from A CBR 600 from Graeme France with Ohlins spring
Graeme France stainless steel down pipes
Professionally polished swing arm.
Engine, good running condition, with cleaned and scuff free stator and clutch covers (not pictured.)
Two subframes, one cut down, the other original.
EBC kevlar clutch kit
All over parts, engine, frame ect. No fairings.
PM if interested
Carbs which have been ultrasonically cleaned and dynojet needles installed
Set of SAMCO hoses.
ZXR 400 front end, fit for NC29, with ZXR 400 front wheel, 310mm brake discs and six pot calipers from GSX-R 1000 with spacer to fit.
Wheels with Bridgestone BT 090 tires, only 300miles on them. Cush rubbers replaced and not used, brand new renthral rear sprocket.
Rear shock from A CBR 600 from Graeme France with Ohlins spring
Graeme France stainless steel down pipes
Professionally polished swing arm.
Engine, good running condition, with cleaned and scuff free stator and clutch covers (not pictured.)
Two subframes, one cut down, the other original.
EBC kevlar clutch kit
All over parts, engine, frame ect. No fairings.
PM if interested
-
- Settled in member
- Reactions:
- Posts: 62
- Joined: Sun Sep 21, 2014 1:54 pm
Re: Breaking apart my NC29 project.
I dont suppose you have the left side air guide? part number 17106-MV4-000
-
- Settled in member
- Reactions:
- Posts: 23
- Joined: Wed Mar 30, 2016 10:25 pm
Re: Breaking apart my NC29 project.
Sent you a pm sir
-
- Settled in member
- Reactions:
- Posts: 10
- Joined: Thu Aug 26, 2010 4:29 pm
Re: Breaking apart my NC29 project.
Does the GF header have balance pipes i between the pipe 1+2 and 3+4?
-
- Site Supporter
- Reactions:
- Posts: 2807
- Joined: Wed Apr 30, 2008 4:47 pm
- Bike owned: CCM404 SM, CBR4/6 in progress
- Location: Nottingham U.K
Re: Breaking apart my NC29 project.
Please can you put a for sale add in the for sale section thanks