NC30 rear engine mount stuck
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- One Hit Wonder
- Reactions:
- Posts: 1
- Joined: Wed Sep 18, 2019 11:43 am
NC30 rear engine mount stuck
Hi guys, I've been trying to remove the last mounting bolt from my NC30 and have run out of ideas, would appreciate some help.
What I have tried so far:
What I have tried so far:
- Hammering it out from the left side
- Heating all areas
- WD40 everywhere
- Following on from this thread, pivoting the engine around it but the entire bolt spins with the engine
- As a last resort, using a hex on the right hand side to keep the bolt in place while pivoting the engine (which just rounded the shit out of it)
- Combinations of all the above
-
- Senior Member
- Reactions:
- Posts: 1910
- Joined: Mon Sep 20, 2010 11:55 pm
- Bike owned: VFR400
- Location: Blue Mountain NSW Australia
Re: NC30 rear engine mount stuck
You are referring to the lower bolt that passes through the engine cases from right to left?