NC23 swing arm bearings
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Senior Member
- Reactions:
- Posts: 1269
- Joined: Thu Aug 19, 2010 1:52 am
- Bike owned: CBR400RR NC23
- Location: West Bromwich UK
- Contact:
NC23 swing arm bearings
unfortunately i don't have access to my haynes manuel but with the swingarm bearings, do 2 bearings fit inside the swingarm and the other in the suspension linkage bit? Also would it be wise to remove it for powdercoating or leave it connected to swingarm when getting it powdercoated?
-
- Senior Member
- Reactions:
- Posts: 1059
- Joined: Sun May 18, 2008 4:51 pm
- Bike owned: CB-1, MSX125
- Location: Gibraltar
Re: NC23 swing arm bearings
3 new threads? Really?
You can't give the coater the arm with the linkage attached.
If you don't know what you're doing, leave it alone... but here is an exploded iagram of how a generic Honda swingarm is put together. Cos I am nice deep down.
You can't give the coater the arm with the linkage attached.
If you don't know what you're doing, leave it alone... but here is an exploded iagram of how a generic Honda swingarm is put together. Cos I am nice deep down.
-
- Senior Member
- Reactions:
- Posts: 1269
- Joined: Thu Aug 19, 2010 1:52 am
- Bike owned: CBR400RR NC23
- Location: West Bromwich UK
- Contact:
Re: NC23 swing arm bearings
3 threads... really?
yes really..
one was for removing swingarm, one was for the swingarm bearings and the other was suspension linkage..
yes really..
one was for removing swingarm, one was for the swingarm bearings and the other was suspension linkage..
-
- Settled in member
- Reactions:
- Posts: 71
- Joined: Mon Apr 14, 2014 8:42 pm
Re: NC23 swing arm bearings
I found this page by searching specifically for "NC23 Swinging Arm Bearings", so I for one support your separating of elements.