CMSMJ1 wrote:

Yakama wrote:Hope he's ok

Yep - what he said.

Mike is one of the good guys, hope he is getting sorted.

Thanks for the well-wishes. I have been through hell with my back. Six surgeries in 3 years. And, I'm not out of the woods yet. It's looking like I need at least one more. Quite possibly two. Here's a bit on that if you want to read more. http://mngforce.typepad.com/nc450vdev/2 ... -wait.html

So, sorry if I haven't responded quickly in the past. But, have no fear, I am still here, still selling parts, and still designing new parts for these bikes. I am currently working on valve train parts to top-off all the bottom end power gains. So, hang tight.

Mike Norman
G-Force Engine Development
www.mngforce.typepad.com

I’d be in for a set...

mscheehle wrote: ↑

Sat Jun 16, 2018 5:04 am

I’d be in for a set...

I have 10 sets of 57mm pistons and +3mm longer rods (pistons must use these rods) in stock. There are no other versions left. Contact me at mngforce@gmail.com